TradeReign
Back to HomeEducation HubCompatibilityAboutDisclosures
Futures Trading Calculators

Futures Margin Calculator Compare Day, Initial and Maintenance Margin

A position can meet day margin at entry and fall short of initial margin even if its price stays flat. This happens when the broker switches to a higher requirement as the session approaches its close. Multiply by the full position size, including contracts you already hold in the product.

Quick Answer

Multiply your broker’s current margin per contract by the number of contracts. Run the calculation again for the requirement that applies if you hold through the session cutoff. Then compare each total with the funds available for that position.

Start 7-Day TrialMore Guides

Compare Futures Margin Requirements

The starting rates are fictional. Enter your broker’s current per-contract rates for one product and the funds available to support this position after accounting for other commitments.

Intraday margin

$300.00 required

$2,700.00 above requirement

Initial margin

$3,600.00 required

$600.00 short

Maintenance margin

$3,200.00 required

$200.00 short

Each comparison uses the same funds for illustration. Check the actual balance and applicable rate when the broker switches requirements. This simple single-product estimate excludes spread offsets and portfolio margin.

Intraday margin

Check eligibility for the broker’s day rate and when it ends for this product.

Initial margin

Check the applicable opening rate and the amount required to carry the position through the session cutoff.

Maintenance margin

Check the minimum required while you continue holding a position that qualifies for this rate.

Comparison

What changes when a broker switches margin rates?

Two MES contracts and $3,000 of available funds. The following rates are fictional, and the example holds funds constant to isolate the effect of changing the requirement.

Requirement
Per contract → position total
Result with $3,000
Intraday
$150 × 2 = $300
$2,700 above the entered requirement
Initial
$1,800 × 2 = $3,600
$600 short at the cutoff
Maintenance
$1,600 × 2 = $3,200
$200 short if this rate later applies

The lower maintenance requirement does not let this position bypass the earlier initial margin check. If you intend to exit before the switch, check the product’s actual cutoff and confirm the closing fills.

Check NinjaTrader intraday margin before the session cutoff

For a NinjaTrader Brokerage account, look up the exact product in NinjaTrader’s margin table and check the session cutoff in its margin policy. The published regular MES example ends day margin at 3:45 p.m. Central, or 4:45 p.m. Eastern, ahead of the 4:00 p.m. Central close. Check the actual trading date, early-close schedule and any temporary rate changes. If the applicable policy starts initial margin 15 minutes before a noon Central close, that puts the cutoff at 11:45 a.m. Central.

In NinjaTrader Desktop, open Control Center → Accounts. Verify the account and connection, then look for Intraday Margin, Initial Margin, Excess Intraday Margin and Excess Initial Margin. Right-click the Accounts grid and use Properties to show hidden columns. The margin columns report requirements. The excess columns report unused room after the applicable requirement. Your connection determines which values are available.

The calculator compares a whole position’s requirement against the funds available to support that position. In the fictional example, enter the $3,000 available before the two MES contracts’ margin is deducted. The intraday result is then $2,700 of excess. If you start with that $2,700 excess and subtract the same $300 again, you count the day-margin requirement twice. Compare the live Excess Initial Margin separately and verify any other positions and reserves on the account.

In the same example, the requirement goes from $300 to $3,600 at the initial-margin cutoff. The $3,000 available now falls $600 short even if price stays flat. Check the broker’s current rate and the account’s actual excess before using the worksheet. A prop-firm account connected to NinjaTrader Desktop can have different limits from a NinjaTrader Brokerage account.

Find the rate that applies to your account and session

Start with the exact product in the broker’s margin table. Match the contract, account type and applicable rate. NinjaTrader publishes Day, Maintenance and Initial columns. Its margin policy also describes changes around economic announcements and the end of a product’s trading session.

Tradovate’s published liquidation policy generally ends intraday margin 15 minutes before the product’s session close, subject to market conditions. Use the cutoff for that product and trading date, especially on an early close. If you aim to be flat, check both the position quantity and any working entry orders that could reopen it.

If there are other positions or pending orders, check how the broker reserves funds across the account. Special rates, spread offsets, portfolio margin and position limits can make the broker’s actual requirement differ from a simple multiplication. Evaluation and funded programs can apply separate rules.

Check dollar risk separately

For the same fictional MES example, a 10-point stop models $50 of stop-only risk per contract because MES is $5 per point. Add $3 per contract for estimated fees and slippage, and two contracts model $106 of risk. With an $80 trade budget, only one fits your risk plan even though two meet the example intraday margin requirement.

The margin comparison tells you where the proposed position stands against the entered collateral requirement. The stop calculation estimates a possible trade outcome. Actual losses can exceed the stop estimate during gaps, slippage or forced liquidation.

Sources

Official References

Platform details on this page were checked against these official resources.

CME Group’s guide to futures marginDefinitions of initial and maintenance margin.CME MES contract specificationsVerify the $5-per-point multiplier for the risk example.NinjaTrader margin tableCurrent broker rates by product.NinjaTrader margin policyRead timing, rate changes and position management rules.NinjaTrader Desktop Accounts tabFind the required and excess margin columns, their meanings, and provider support.Tradovate margin and liquidation policyRead the day-rate cutoff and broker liquidation terms.
Related Guides

Keep Building the Rule System

Calculate futures position size

Use your stop, costs and risk budget to estimate how many contracts fit your plan.

Calculate gross futures contract value

Convert the quote and multiplier to notional exposure, then check how many contracts fit a dollar limit.

Compare NinjaTrader and Tradovate

Compare how the two platforms handle accounts, connections and order workflows.

Verify the MES session hours

Check the product and day before converting the margin cutoff to your chart’s clock.

FAQ

Common Questions

Where can I find available intraday margin in NinjaTrader Desktop?

Open Control Center → Accounts and look for Excess Intraday Margin on the correct account row. Use the grid’s Properties to show the column if needed. Which values appear depends on the connection.

Is intraday margin the same as initial margin?

Intraday margin is the broker’s requirement when the position qualifies for its day rate. Initial margin applies when the broker requires the full initial rate, including at the cutoff to carry a position into the next session. The broker’s policy tells you when each applies.

Can I use maintenance margin to open a futures position?

Maintenance margin generally applies to a qualifying position that is already open and has been carried forward. Check the broker’s applicable opening or initial margin before placing an order.

What if my funds fall below the requirement?

The broker may restrict new orders, demand more funds, reduce positions or liquidate them according to its policy. Liquidation fees may apply. Check the broker’s rules for the account and product.

Risk Disclosure

Futures trading contains substantial risk and is not suitable for every investor. TradeReign is a trading-discipline and rule-enforcement application. It does not provide trading advice, trade signals, investment recommendations, or performance guarantees.

TradeReign is not a broker-dealer, futures commission merchant, or investment advisor.

Futures trading contains substantial risk and is not for every investor. An investor could potentially lose all or more than the initial investment. Only risk capital - money that can be lost without jeopardizing financial security or lifestyle - should be used for trading. Past performance is not necessarily indicative of future results.