Weight by contracts
A fill of two contracts contributes twice as much to the average as a fill of one.

Enter same-side fills for one dated contract and the quantities still open. The starting numbers are fictional. Leave the stop blank to calculate average entry only.
6,000.00 average entry
1 contract
-$50.00 gross and -$53.00 after the allowance at the modeled stop.
5,997.333333 average entry
3 contracts
-$110.00 gross and -$119.00 after the allowance at the modeled stop.
The average can fall between valid ticks. Each individual fill and stop must use valid ticks. The stop scenario assumes every contract exits at the entered price. Actual fills and costs can differ.
A fill of two contracts contributes twice as much to the average as a fill of one.
Every fill and stop should be on the contract’s tick grid. The weighted mean may fall between ticks.
The change in total modeled P&L shows how added contracts affect the position at that price.
In this fictional MES long, the open fill is one contract at 6,000.00. The proposed add is two contracts at 5,996.00. The stop remains 5,990.00 and estimated costs are $3 per contract.
The average moves closer to the stop while the estimated loss grows by $66. Compare that change with the risk budget you wrote before the setup.
For the example, use (6,000 × 1 + 5,996 × 2) ÷ 3. An average of the two quoted prices alone gives 5,998.00 and ignores the unequal quantities.
The exact aggregate stop calculation uses each fill without rounding its average to a tick. At the MES multiplier of $5 per point, 10 points on the first contract is $50. Six points across the two added contracts is another $60. Then account for estimated costs on all three contracts.
Use only the fills and quantities that still make up the open position. If you tracked three entry contracts and later closed one, check your broker’s remaining cost basis before entering the other two. Cost-basis matching and displayed rounding can differ across platforms.
Use separate calculations for different expiries or instruments. An MES December fill and an MES March fill have their own prices and positions. For completed trades, use actual exit fills and fees to calculate realized P&L.
Before comparing, verify the stop price, which contracts it would cover and your remaining account risk room. This calculator models one exit price on every entered contract. If you manage separate stop levels, calculate each covered group separately.
A stop price is a scenario for estimating risk. A gap, a rejected order or price slippage can change what happens. Compare the model with working orders and use realistic costs before relying on the number.
Platform details on this page were checked against these official resources.
See a fictional chart that traces a scale-in and stop change.
Estimate each covered group separately and compare the total with the risk budget.
Reconcile actual entry and exit fills for a completed trade.
Yes. The weighted average of valid fills can fall between ticks. Keep fill prices and any modeled order price on the tick grid, and use the original fills for the dollar calculation.
It uses the open fills you enter and, optionally, the proposed add. It models P&L at a hypothetical full exit. Previously closed quantities and their realized P&L belong in your completed-trade records.
Futures trading contains substantial risk and is not suitable for every investor. TradeReign is a trading-discipline and rule-enforcement application. It does not provide trading advice, trade signals, investment recommendations, or performance guarantees.
TradeReign is not a broker-dealer, futures commission merchant, or investment advisor.
Futures trading contains substantial risk and is not for every investor. An investor could potentially lose all or more than the initial investment. Only risk capital - money that can be lost without jeopardizing financial security or lifestyle - should be used for trading. Past performance is not necessarily indicative of future results.