TradeReign
Back to HomeEducation HubCompatibilityAboutDisclosures
Futures Order Flow

Stacked Imbalances on Footprint Charts A Three-Level Buy Stack and a One-Contract Near Miss

Use a completed bar and pick the settings before reading the result. The two fictional MES footprints below use one tick per row, a 3:1 buy ratio, and at least three adjacent qualifying price levels. They differ by one sell contract.

Quick Answer

A stacked imbalance is a run of qualifying buy or sell imbalances at consecutive prices in the same footprint bar. A buy imbalance compares a row’s buy volume with sell volume one row lower. A sell imbalance compares a row’s sell volume with buy volume one row higher. The threshold and required number of rows depend on your settings.

Start 7-Day TrialMore Guides
Three adjacent buy imbalances
PriceSellBuyBuy ratio
6,001.503152.50×
6,001.256313.10× buy imbalance
6,001.0010373.08× buy imbalance
6,000.7512463.07× buy imbalance
6,000.5015182.25×
6,000.2584—
The middle row misses
PriceSellBuyBuy ratio
6,001.503152.50×
6,001.256313.10× buy imbalance
6,001.0010372.85×
6,000.7513463.07× buy imbalance
6,000.5015182.25×
6,000.2584—
Synthetic MES contracts traded by price. Green marks qualifying diagonal buy ratios. The lowest price has no lower row for a buy comparison.

Count consecutive prices before calling it a stack

Read the buy cell at 6,001.00 against the sell cell below it at 6,000.75. In the first footprint, 37 ÷ 12 is about 3.08. The rows just above and below 6,001.00 also qualify, so the stack runs from 6,000.75 to 6,001.25.

In the second footprint only the sell cell at 6,000.75 changes, from 12 to 13. The buy ratio one row higher falls to about 2.85. The upper and lower rows still qualify individually. The missing middle row breaks the run even though total bar delta only changes from +97 to +96 contracts.

Log the earliest time you could score the pattern under your rule. This exercise scores it at the bar close. Then record whether and when a later bar first reaches the band. A revisit can occur with or without a favorable reaction, and it does not establish whether a hypothetical order filled.

Match TradingView and NinjaTrader imbalance settings

In TradingView’s Volume footprint settings, set Ticks per Row to 1 using Manual row size, then set the Imbalance threshold to 300%. Enable Highlighting and set Stacked levels to three for this exercise. TradingView can project stacked levels until a later price intersects them. Keep the original bar and its settings in your notes if you want to review a zone after that intersection.

In NinjaTrader Desktop, use Order Flow Volumetric with Ticks per level set to 1. Check the imbalance mode, Imbalance ratio and Minimum delta for imbalance. For example, a minimum diagonal delta of 26 contracts would filter out 31 versus 10 and 37 versus 12 in the first footprint. Only 46 versus 15 still meets both thresholds. Count adjacent qualifying rows on the completed bar.

If the comparison cell is missing, leave the row unscored. If it is zero, check your platform’s zero-volume convention and record it. A small positive numerator can produce a large ratio on a thin row, so note any minimum volume or delta filter. To compare platforms, also match the dated contract, session and bar interval, and check whether buy and sell volumes are inferred from smaller time bars or classified from tick data.

Sources

Official References

Platform details on this page were checked against these official resources.

TradingView Volume Footprint guideDiagonal comparisons, highlighting, row size and stacked levels.NinjaTrader Order Flow Volumetric guideImbalance ratio, minimum diagonal delta, and ticks per level.
Related Guides

Keep Building the Rule System

Set up a TradingView footprint chart

Compare tick-based and aggregated volume before reading imbalances.

Read unfinished auctions at footprint extremes

Check two cells on the same price row at the bar’s high or low.

Compare a footprint with cumulative delta

Check the calculation mode and anchor before reconciling bar totals.

FAQ

Common Questions

Do three highlighted levels always make a stacked imbalance?

Under a three-level rule, they must be consecutive, on the same side, and in the same bar. A missing or nonqualifying row interrupts the stack.

Is a stacked imbalance the same as positive volume delta?

A stack uses adjacent diagonal comparisons. Bar delta sums buy volume minus sell volume across the entire bar. Both sample bars have strongly positive delta, and only one has a three-level buy stack.

Risk Disclosure

Futures trading contains substantial risk and is not suitable for every investor. TradeReign is a trading-discipline and rule-enforcement application. It does not provide trading advice, trade signals, investment recommendations, or performance guarantees.

TradeReign is not a broker-dealer, futures commission merchant, or investment advisor.

Futures trading contains substantial risk and is not for every investor. An investor could potentially lose all or more than the initial investment. Only risk capital - money that can be lost without jeopardizing financial security or lifestyle - should be used for trading. Past performance is not necessarily indicative of future results.