High and low
Use all trades in the defined first hour. Include the highs and lows of the bars, including their wicks.

Synthetic MES 15-minute candles. Times are bar closes in ET.
The dashed lines mark the completed Initial Balance. Marker 1 ends the first hour. Marker 2 closes above the 6,018.00 high at 6,019.50.
Use all trades in the defined first hour. Include the highs and lows of the bars, including their wicks.
Average the high and low. For 6,018.00 and 5,998.00, the midpoint is 6,008.00.
Evaluate breakout closes after the range is complete. On this 15-minute chart, the first eligible close is at 10:45 a.m. ET.
Choose the dated futures contract, session start, and chart time zone before marking levels. For this hypothetical MES session, use 9:30–10:30 a.m. ET. The four 15-minute bars end at 9:45, 10:00, 10:15, and 10:30. The fourth represents the interval from 10:15 up to 10:30. If your chart labels bars by opening time, the same bars start at 9:30, 9:45, 10:00, and 10:15.
Take the highest high and lowest low across those four bars. The example reaches 6,018.00 and 5,998.00, making a 20-point Initial Balance with a 6,008.00 midpoint. Draw the levels after 10:30. The finished levels are shown over the first hour on this teaching chart so you can see which bars set them.
In this same example, a trader using a 15-minute opening range freezes 6,010.00 and 6,000.00 at 9:45. The 10:00 close at 6,012.00 is outside that opening range. At 10:00 the 60-minute Initial Balance is still forming. Both descriptions can be correct for the same bar.
Once the first hour is complete, the 10:45 bar in the first scenario closes at 6,019.50, above the 6,018.00 Initial Balance high. In the second scenario, its high reaches 6,020.00 but it closes at 6,016.00. A close-based review records that second scenario as an excursion.
Wait for the first hour to finish, then subtract the Initial Balance low from the high. In the example, 6,018.00 minus 5,998.00 gives a 20-point range. A 50% extension is 10 points beyond either edge, at 6,028.00 above or 5,988.00 below. A 100% extension is 20 points beyond either edge, at 6,038.00 above or 5,978.00 below.
Check where your tool starts measuring. The upside level 6,028.00 is 0.5 range widths above the high and 1.5 widths above the low. A tool that labels it 1.5× may be showing the same level as a tool that labels it 50%. Compare the actual price before copying a multiplier between tools.
In Sierra Chart’s Initial Balance study, enter 0.5 in Extension Multiplier 1 and 1 in Extension Multiplier 2. In Subgraphs, change the corresponding Draw Styles from Ignore to Line to display them. When using its inclusive Start/End Time method on a chart set to New York time, 9:30:00 through 10:29:59 excludes the bar that starts at 10:30. Enable Round Extensions to Tick Size if you want the levels aligned with the chart’s tick size.
In replay, record the first touch and the first close beyond a level separately. The 11:15 bar touches 6,028.00, but 11:30 is the first close above. The high of 6,037.75 at 11:45 misses the 100% line by one MES tick. Count that line as untouched through the example cutoff. The lines are reference prices for reviewing range expansion.
Synthetic MES 15-minute candles. Times are bar closes in ET.
After the first hour, the 11:00 bar misses 6,028.00 by one tick. The 11:15 bar touches it and closes below. The first close beyond it is 11:30. The 6,038.00 level remains untouched through the final bar.
An opening type describes how the auction moves around the opening price. Initial Balance measures the high and low across a defined window. This exercise watches the first 30 minutes after 9:30 a.m. ET, while the 60-minute Initial Balance is still developing. The 30-minute window is a teaching choice.
All four fictional MES examples start at 6,000.00, inside the prior value area from 5,998.00 to 6,004.00. An open-drive moves away and holds one side of the opening price. An open-test-drive first probes a reference in one direction, then moves decisively the other way. The first example drives higher immediately. The second reaches prior value low first.
An open-rejection-reverse begins with a directional move, loses that direction, and trades back through the opening price. In the example, it starts with the same 9:35 bar as the open-drive and only shows the reversal on later bars. An open-auction repeatedly rotates around the opening price. This example is within prior value. The same back-and-forth structure can occur outside the previous day’s range.
Before applying a label in Replay, mark the opening price and any reference levels already known, and note how much of the sequence you have seen. On an unclear opening, leave the label open or revise it with an as-of timestamp. To study what follows, define a separate outcome window and record every example, including unclear cases. The four shapes describe early price action. They do not establish the direction or range of the rest of the day.
Synthetic MES 5-minute candles. Times are bar closes in ET.
The first candle pushes up from 6,000.00. The next five candles stay above the open and extend higher. The same first candle appears in the rejection-reverse example, so it cannot determine the opening type on its own.
In a close-based replay drill, flag an upside failure when a bar closes above the completed Initial Balance high and a later bar closes back inside it. The Chicago Board of Trade’s Market Profile study guide looks for lack of follow-through and uses extension on the opposite side to classify a failed range extension. Log the return inside and any later extension as separate events.
The three MES paths share a 10:45 a.m. ET close at 6,019.50, above the 6,018.00 Initial Balance high. Two paths close back inside at 11:00 and trade through the 6,008.00 midpoint by 11:15. Only one extends below the 5,998.00 low before the 11:30 cutoff. In the third path, price keeps trading outside the range. Its 10:30–11:00 and 11:00–11:30 periods both trade above the high.
ShadowTrader’s look above and fail applies its balance rules to a range formed over two or more days. Mark that range separately before using the term. Its acceptance glossary looks for evidence across TPO periods. To study the first-hour setup shown here, record the boundary, first outside close, first return inside, midpoint, and opposite-edge result through your stated cutoff. A move to the far edge is an outcome to measure.
Synthetic MES 15-minute candles. Times are bar closes in ET.
At 11:00 a.m. ET, price has closed back below the IB high. The 11:15 bar trades through 6,008.00. Through the 11:30 cutoff, the opposite edge at 5,998.00 is still untouched.
Choose whether you count a first trade beyond the level or require a completed bar close. Track the first occurrence, which side it crossed, and whether a later bar closed back inside. Also record sessions where neither side meets your rule or where both sides do.
Keep the identical time window on every chart you compare and note holiday or shortened sessions. In NinjaTrader’s Order Flow Volume Profile, the Initial Balance duration is a configurable number of minutes. Check which session your profile starts from before comparing it with hand-marked levels.
Journal the range width and the sequence before looking at a hypothetical trade outcome. A break or a return to the midpoint is a chart observation. A trade test needs separately defined entries, exits, and costs.
Platform details on this page were checked against these official resources.
Separate a confirmed Market Profile setup from an early touch of the far edge.
Spot interior single prints, a poor low, and excess after the initial balance period.
Find the point of control and value area for a completed futures session.
Match the indicator window and compare three different closes against the range high.
Check the closing times and use the Data Box to verify the range levels.
Check which trades belong to each session window.
See how the optional installed strategy uses the opening range and Initial Balance.
Compare which events count as a breakout in a close-based drill.
Mark the range as the first hour develops.
Price attempts to extend beyond the first-hour range and loses follow-through. In a replay drill you can timestamp a close back inside, then record any extension through the opposite edge separately. The CBOT study guide uses opposing extension when classifying a failed range extension.
It is half the completed Initial Balance width projected beyond the high or low. If the first-hour range is 20 points, the extension lies 10 points beyond the relevant edge.
An open-drive describes early movement away from the opening price. An Initial Balance breakout needs completed initial balance levels. The opening can drive in one direction long before those levels are final.
Sixty minutes is a common definition. Decide which session and duration you are using before reviewing the chart. Some platform studies let you configure the number of minutes.
If your exercise uses the first hour after the U.S. cash open at 9:30 a.m. ET, it ends at 10:30 a.m. ET. ES and MES trade outside those hours. A study based on a different session start produces different levels.
Initial Balance commonly uses the first hour. An opening-range setup might use the first 5, 15, or 30 minutes, for example. Name the session start and duration before comparing any two ranges.
Futures trading contains substantial risk and is not suitable for every investor. TradeReign is a trading-discipline and rule-enforcement application. It does not provide trading advice, trade signals, investment recommendations, or performance guarantees.
TradeReign is not a broker-dealer, futures commission merchant, or investment advisor.
Futures trading contains substantial risk and is not for every investor. An investor could potentially lose all or more than the initial investment. Only risk capital - money that can be lost without jeopardizing financial security or lifestyle - should be used for trading. Past performance is not necessarily indicative of future results.