Sell-side sweep below a prior low
Price moves three MES ticks below the 5,998.00 prior low and the 9:45 bar closes back above it at 5,999.00. The close confirms the guide’s sell-side sweep example.


The 9:45 candle shows both crossings and a close inside the range. The order of the two crossings is unknown from the candle alone.
Open the full-size chartSynthetic MES 5-minute candles. Times are bar closes in ET.
Price moves three MES ticks below the 5,998.00 prior low and the 9:45 bar closes back above it at 5,999.00. The close confirms the guide’s sell-side sweep example.
Price moves three MES ticks below the 5,998.00 prior low and the 9:45 bar closes back above it at 5,999.00. The close confirms the guide’s sell-side sweep example.
The two pivot highs are one tick apart and both are confirmed by 9:55. The 10:00 bar reaches 6,002.75, two ticks above the upper high of 6,002.25, and closes back below at 6,001.00.
Price trades under 5,998.00 and stays below it at both closes. That crosses the reference, but the one-bar sweep rule requires a reclaim on the crossing bar.
The 9:45 MES bar crosses 6,002.00 and 5,998.00, then closes inside at 6,000.25. The candle confirms both excursions by the close. It leaves their order unknown.
Start with a previous session high or low, an already confirmed swing or another predefined reference. Write which session supplied the level and its price. A touch at exactly the level fails the one-tick-beyond condition.
Buy-side refers to the area above a reference high. Sell-side refers to the area below a reference low. The labels describe where price traveled, regardless of what it does after the sweep.
ICT's 2022 Mentorship Episode 3 uses relative equal highs as a reference for buy-side liquidity. For this MES example, define a pivot high as a bar with lower highs on both adjacent bars. Treat two completed pivots as relatively equal if their highs are within one tick. One tick is the tolerance for this exercise.
The 9:40 high is 6,002.00 and the 9:50 high is 6,002.25. The second pivot becomes visible under this rule when the next bar closes at 9:55. Freeze both prices then and use the upper edge, 6,002.25, as the sweep reference. A bar touching 6,002.25 or crossing only the lower high cannot sweep that upper edge under this rule.
The 10:00 bar trades to 6,002.75 and closes at 6,001.00, so it meets the one-bar rule. For relative equal lows, require higher lows on both adjacent bars and use the lower edge as the reference. Record the confirmation time before testing the sweep. Price action at the reference cannot tell you how many stops were there.
This example uses the same bar for the break and return. A trader using a two-bar or five-bar reclaim window will label some events differently. Pick the window before testing it and record the close when the criterion is first satisfied.
A close beyond the reference is a breakout candidate under a close-based rule. For example, you could require another close beyond the level before calling it a sustained break. Track that later confirmation separately. A sweep can also be followed by another attempt at the same level.
In the fourth chart, freeze the two-bar range at 9:40 a.m. ET. The 9:45 candle reaches 6,002.75 and 5,997.50 before closing at 6,000.25. Both sides meet the one-bar price test. Record the two-sided event at 9:45 instead of assigning it a direction from the candle color.
The same five-minute candle could have reached the high first or the low first. If your setup needs one side to break first, replay that five-minute window on finer bars or a recorded trade stream for the same contract. If the finer bars still combine both crossings or the records are missing, keep the order of events unknown. The five-minute close is when the two-sided label becomes known under this drill’s rule.
Platform details on this page were checked against these official resources.
Compare the concepts and practice marking them in replay.
Read bullish and bearish ICT fair value gaps on MES charts. Calculate consequent encroachment and distinguish a midpoint touch from a full revisit.
Draw an ICT balanced price range from two opposing fair value gaps. Compare one-tick overlap and touching edges on paired MES charts.
Compare bullish and bearish ICT market structure shifts, a wick-only break, and two futures charts with the same shift that may or may not form a fair value gap.
Compare bullish and bearish ICT order block examples on fictional MES candles. Mark the originating candle, confirming close and separate fair value gap.
Read bullish and bearish ICT displacement candles on fictional MES charts. Measure the body and close, and compare a wide wick that fails the rule.
Draw an ICT Optimal Trade Entry zone on fictional MES candles. Use the 62%, 70.5%, and 79% levels, check valid ticks, and avoid hindsight in replay.
Mark ICT kill zones in New York time on a futures chart. Use fictional MES bars to distinguish window boundaries, cash open and daylight saving.
Compare ICT SMT divergence examples on paired MES and MNQ charts. Match bar closes and use known reference highs or lows to check the disagreement.
See an ICT inversion fair value gap form in both directions on fictional MES charts. Compare a confirming close beyond the zone with a wick-only break.
Compare bullish and bearish ICT breaker blocks with a matching no-sweep example. See which candle confirms the break and when a retest can count.
Compare bullish and bearish ICT Unicorn setups on synthetic MES charts. Measure the breaker and fair value gap overlap, including a zero-width near miss.
Find the three ICT Silver Bullet times in New York, Chicago and UTC. Compare three fictional MES charts with gap confirmations and cutoff examples.
Compare bullish, bearish and failed ICT Power of Three sequences on synthetic MES charts. Freeze the range and check each phase in order.
Mark an ICT dealing range on synthetic MES charts. Calculate equilibrium and see why the same price can be premium in one range and discount in another.
See where an internal fair value gap and an external range high sit on two synthetic MES charts. Label a price using a range fixed before the move.
Mark a prior session high or low before the move. Three fictional MES charts show the target first, the opposite side first, and a bar that reaches both.
Learn how to write an ICT daily bias before the move and compare three fictional MES replays where the draw is met, invalidated or expires.
Compare bullish, bearish and late-reclaim ICT Judas Swing examples on synthetic MES charts with a fixed overnight range and New York clock.
Keep the chart session and time zone consistent when selecting a reference.
Under this guide’s rule, the bar has to trade through the reference by at least one tick and close back on the original side. A close beyond the reference or exactly on it fails that test.
Futures trading contains substantial risk and is not suitable for every investor. TradeReign is a trading-discipline and rule-enforcement application. It does not provide trading advice, trade signals, investment recommendations, or performance guarantees.
TradeReign is not a broker-dealer, futures commission merchant, or investment advisor.
Futures trading contains substantial risk and is not for every investor. An investor could potentially lose all or more than the initial investment. Only risk capital - money that can be lost without jeopardizing financial security or lifestyle - should be used for trading. Past performance is not necessarily indicative of future results.