TradeReign
Back to HomeEducation HubCompatibilityAboutDisclosures
ICT Concepts for Futures

ICT Power of Three: Accumulation, Manipulation and Distribution Read the Annotated Futures Charts

A wick through a range edge gives you a candidate for the model. What happens next determines whether the sequence completes. Compare three fictional MES paths with the same 5,999.00–6,004.00 starting range.

Quick Answer

ICT Power of Three, or AMD, describes a range, an excursion through one side and a move in the other direction. In this replay exercise, freeze the range first, require a close back inside after the sweep, then wait for a later close through the opposite edge.

Start 7-Day TrialMore Guides

Power of Three chart examples

Synthetic MES 5-minute candles. Times are bar closes in ET.

At 9:50 a.m. ET, price sweeps the low and closes back inside. The 9:55 close is still inside. Only the 10:00 close at 6,004.50 completes the bullish sequence under the exercise rule.

Bullish sequence

At 9:50 a.m. ET, price sweeps the low and closes back inside. The 9:55 close is still inside. Only the 10:00 close at 6,004.50 completes the bullish sequence under the exercise rule.

Bearish sequence

At 9:50, price trades to 6,004.50 and closes back below 6,004.00. The 10:00 candle closes at 5,998.75, completing the mirrored bearish sequence below the opposite edge.

Sweep with no reversal

The same 9:50 low sweep and reclaim appear as in the bullish example. The next candle closes below the range, then price extends lower. There is no bullish confirmation by 10:00.

Freeze the range before scoring the sweep

This exercise uses the three completed five-minute bars ending at 9:35, 9:40 and 9:45 a.m. New York time. At 9:45, the highest price is 6,004.00 and the lowest is 5,999.00. Keep those prices fixed when you advance the replay.

In the ICT terminology, accumulation refers here to the initial range, manipulation to the excursion beyond an edge, and distribution to the ensuing directional move. These labels describe chart structure. A candle reveals traded prices, with no evidence of a participant’s intent.

Record the sweep, reclaim and opposite break

For this drill, require a wick strictly outside the range and a close strictly inside it. Then require a later completed candle to close strictly beyond the opposite edge by 10:00 a.m. ET, including the bar closing at 10:00. The 15-minute initial range, close rule and cutoff are choices for this lesson.

A sweep and reclaim of the low is a bullish candidate from 9:50 in two charts. Only one goes on to close above 6,004.00. The third chart takes out the high first and then closes below 5,999.00. Keep failed, unconfirmed and ambiguous sequences in the journal. If a bar trades past both edges, its OHLC alone cannot tell you which happened first.

Write the prices and timestamps before advancing the chart. Score a rule on what was known by that cutoff. An opposite-edge close provides a way to classify these examples. It does not establish whether a simulated order would fill or whether the model has an edge.

Sources

Official References

Platform details on this page were checked against these official resources.

The Inner Circle Trader’s AMD lessonOriginal discussion of accumulation, manipulation and distribution. The futures examples and scoring rule here are original to TradeReign.
Related Guides

Keep Building the Rule System

All ICT chart lessons

Compare the concepts and practice marking them in replay.

Fair Value Gap examples

Read bullish and bearish ICT fair value gaps on MES charts. Calculate consequent encroachment and distinguish a midpoint touch from a full revisit.

Balanced Price Range examples

Draw an ICT balanced price range from two opposing fair value gaps. Compare one-tick overlap and touching edges on paired MES charts.

Liquidity Sweep examples

Compare ICT liquidity sweeps with closes beyond the range on synthetic MES charts. Learn what a candle can tell you when it crosses both sides.

Market Structure Shift examples

Compare bullish and bearish ICT market structure shifts, a wick-only break, and two futures charts with the same shift that may or may not form a fair value gap.

Order Block examples

Compare bullish and bearish ICT order block examples on fictional MES candles. Mark the originating candle, confirming close and separate fair value gap.

Displacement Candle examples

Read bullish and bearish ICT displacement candles on fictional MES charts. Measure the body and close, and compare a wide wick that fails the rule.

Optimal Trade Entry examples

Draw an ICT Optimal Trade Entry zone on fictional MES candles. Use the 62%, 70.5%, and 79% levels, check valid ticks, and avoid hindsight in replay.

Kill Zones examples

Mark ICT kill zones in New York time on a futures chart. Use fictional MES bars to distinguish window boundaries, cash open and daylight saving.

SMT Divergence examples

Compare ICT SMT divergence examples on paired MES and MNQ charts. Match bar closes and use known reference highs or lows to check the disagreement.

Inversion Fair Value Gap examples

See an ICT inversion fair value gap form in both directions on fictional MES charts. Compare a confirming close beyond the zone with a wick-only break.

Breaker Block examples

Compare bullish and bearish ICT breaker blocks with a matching no-sweep example. See which candle confirms the break and when a retest can count.

Unicorn Model examples

Compare bullish and bearish ICT Unicorn setups on synthetic MES charts. Measure the breaker and fair value gap overlap, including a zero-width near miss.

Silver Bullet Times examples

Find the three ICT Silver Bullet times in New York, Chicago and UTC. Compare three fictional MES charts with gap confirmations and cutoff examples.

Dealing Range examples

Mark an ICT dealing range on synthetic MES charts. Calculate equilibrium and see why the same price can be premium in one range and discount in another.

Internal vs. External Range Liquidity examples

See where an internal fair value gap and an external range high sit on two synthetic MES charts. Label a price using a range fixed before the move.

Draw on Liquidity examples

Mark a prior session high or low before the move. Three fictional MES charts show the target first, the opposite side first, and a bar that reaches both.

Daily Bias examples

Learn how to write an ICT daily bias before the move and compare three fictional MES replays where the draw is met, invalidated or expires.

Judas Swing examples

Compare bullish, bearish and late-reclaim ICT Judas Swing examples on synthetic MES charts with a fixed overnight range and New York clock.

Replay an AMD sequence one close at a time

Log the frozen range, excursion, reclaim and opposite-edge close as separate observations.

FAQ

Common Questions

Does a liquidity sweep confirm ICT Power of Three?

A sweep marks one event in the sequence. In this exercise, the sweep must reclaim the range, and a later candle must close through the opposite edge within the review window.

Risk Disclosure

Futures trading contains substantial risk and is not suitable for every investor. TradeReign is a trading-discipline and rule-enforcement application. It does not provide trading advice, trade signals, investment recommendations, or performance guarantees.

TradeReign is not a broker-dealer, futures commission merchant, or investment advisor.

Futures trading contains substantial risk and is not for every investor. An investor could potentially lose all or more than the initial investment. Only risk capital - money that can be lost without jeopardizing financial security or lifestyle - should be used for trading. Past performance is not necessarily indicative of future results.