TradeReign
Back to HomeEducation HubCompatibilityAboutDisclosures
ICT Concepts for Futures

ICT Rejection Block: Mark the Wick and Read the Retest Read the Annotated Futures Charts

The bearish examples use identical fictional five-minute MES candles through 9:55 a.m. New York time. Compare the 10:00 bars. One trades into the wick zone and closes back below it. The other closes above its far edge. The bullish chart mirrors the first sequence so you can practice drawing the lower wick zone.

Quick Answer

An ICT rejection block is the wick-side price zone at a swing extreme. At a bearish swing, draw from the highest open or close in the swing to the highest wick. At a bullish swing, draw from the lowest wick to the lowest open or close. On a later test, record the wick’s reach and the closing price separately.

Start 7-Day TrialMore Guides

Rejection Block chart examples

Synthetic MES 5-minute candles. Times are bar closes in ET.

The 9:45 candle opens at 6,002.75, reaches 6,006.50 and closes at 6,002.00. The upper wick starts at the open in this down candle. At 10:00, the high of 6,005.25 is inside the zone and the 6,002.25 close is below its near edge.

Bearish wick retest

The 9:45 candle opens at 6,002.75, reaches 6,006.50 and closes at 6,002.00. The upper wick starts at the open in this down candle. At 10:00, the high of 6,005.25 is inside the zone and the 6,002.25 close is below its near edge.

Bearish zone fails

The 10:00 candle closes at 6,006.75, one MES tick above the 6,006.50 tip. Under this exercise’s close-based rule, remove the zone from the list of active bearish references at that close.

Bullish wick retest

The 9:45 candle reaches 5,993.50, opens at 5,997.25 and closes at 5,998.00. The lower wick ends at the open. At 10:00 the low of 5,994.75 is inside the zone and the 5,997.75 close is back above its near edge.

Use the body edge and confirm the swing

On standard candles, the body top is the higher of the open and close. The body bottom is the lower. Find the wick tip and the highest body edge of the bearish swing, or the lowest body edge of the bullish swing. They can belong to different candles. In these charts, both prices come from the 9:45 bar and the zone spans 3.75 points, or 15 MES ticks.

Write down the bars that define your swing before reviewing a retest. This exercise uses one neighboring bar on either side of the extreme. The 9:45 wick is visible when that bar closes. Its high is above both neighboring highs only once the 9:50 bar closes, so the swing and its zone are first confirmed then. The same rule compares lows in the bullish case.

Distinguish a touch, a rejection and a close through

For the bearish example, a later bar can reach 6,002.75 and close inside the zone. Record that as a touch awaiting resolution. A bar reaching the zone and closing below 6,002.75 meets this exercise’s same-bar rejection rule. A close strictly above 6,006.50 invalidates the reference. Reverse the inequalities for the bullish example.

A wick past the tip can hit an intrabar stop even if the bar closes back inside the zone. Keep any simulated stop and the close-based chart label in separate columns. Log the reference time, the retest high or low and the close. Include chart segments where price never returns.

Rejection block vs. order block and liquidity sweep

The rejection block marks a wick-side zone at an extreme. The order block exercise maps a selected origin candle before a displacement move. The liquidity sweep exercise records the event when price trades past an earlier level and reclaims it. In the bearish example, 6,004.50 is the earlier high that gets swept. The two rejection-block boundaries are 6,002.75 and 6,006.50.

Sources

Official References

Platform details on this page were checked against these official resources.

The Inner Circle Trader’s rejection block lessonThe original mentorship explains the wick and body references. The five-minute candles and retest labels here are TradeReign’s exercise.
Related Guides

Keep Building the Rule System

All ICT chart lessons

Compare the concepts and practice marking them in replay.

Fair Value Gap examples

Read bullish and bearish ICT fair value gaps on MES charts. Calculate consequent encroachment and distinguish a midpoint touch from a full revisit.

Balanced Price Range examples

Draw an ICT balanced price range from two opposing fair value gaps. Compare one-tick overlap and touching edges on paired MES charts.

Liquidity Sweep examples

Compare ICT liquidity sweeps with closes beyond the range on synthetic MES charts. Learn what a candle can tell you when it crosses both sides.

Market Structure Shift examples

Compare bullish and bearish ICT market structure shifts, a wick-only break, and two futures charts with the same shift that may or may not form a fair value gap.

Order Block examples

Compare bullish and bearish ICT order block examples on fictional MES candles. Mark the originating candle, confirming close and separate fair value gap.

Displacement Candle examples

Read bullish and bearish ICT displacement candles on fictional MES charts. Measure the body and close, and compare a wide wick that fails the rule.

Optimal Trade Entry examples

Draw an ICT Optimal Trade Entry zone on fictional MES candles. Use the 62%, 70.5%, and 79% levels, check valid ticks, and avoid hindsight in replay.

Kill Zones examples

Mark ICT kill zones in New York time on a futures chart. Use fictional MES bars to distinguish window boundaries, cash open and daylight saving.

SMT Divergence examples

Compare ICT SMT divergence examples on paired MES and MNQ charts. Match bar closes and use known reference highs or lows to check the disagreement.

Inversion Fair Value Gap examples

See an ICT inversion fair value gap form in both directions on fictional MES charts. Compare a confirming close beyond the zone with a wick-only break.

Breaker Block examples

Compare bullish and bearish ICT breaker blocks with a matching no-sweep example. See which candle confirms the break and when a retest can count.

Unicorn Model examples

Compare bullish and bearish ICT Unicorn setups on synthetic MES charts. Measure the breaker and fair value gap overlap, including a zero-width near miss.

Silver Bullet Times examples

Find the three ICT Silver Bullet times in New York, Chicago and UTC. Compare three fictional MES charts with gap confirmations and cutoff examples.

Power of Three examples

Compare bullish, bearish and failed ICT Power of Three sequences on synthetic MES charts. Freeze the range and check each phase in order.

Dealing Range examples

Mark an ICT dealing range on synthetic MES charts. Calculate equilibrium and see why the same price can be premium in one range and discount in another.

Internal vs. External Range Liquidity examples

See where an internal fair value gap and an external range high sit on two synthetic MES charts. Label a price using a range fixed before the move.

Draw on Liquidity examples

Mark a prior session high or low before the move. Three fictional MES charts show the target first, the opposite side first, and a bar that reaches both.

Daily Bias examples

Use completed daily candles to form a bullish, bearish or neutral ICT bias. Check whether the target traded overnight, then follow the plan on a MES replay.

Judas Swing examples

Compare bullish, bearish and late-reclaim ICT Judas Swing examples on synthetic MES charts with a fixed overnight range and New York clock.

Practice marking rejection blocks in Bar Replay

Pause at the confirming close, mark both prices and record what the first later touch does.

FAQ

Common Questions

Do you mark an ICT rejection block from the close or from the open?

Use the body edge facing the wick. The upper body edge is the higher of open and close, and the lower body edge is the lower. When the swing spans multiple candles, use the highest upper body edge for a bearish block or the lowest lower body edge for a bullish block.

Risk Disclosure

Futures trading contains substantial risk and is not suitable for every investor. TradeReign is a trading-discipline and rule-enforcement application. It does not provide trading advice, trade signals, investment recommendations, or performance guarantees.

TradeReign is not a broker-dealer, futures commission merchant, or investment advisor.

Futures trading contains substantial risk and is not for every investor. An investor could potentially lose all or more than the initial investment. Only risk capital - money that can be lost without jeopardizing financial security or lifestyle - should be used for trading. Past performance is not necessarily indicative of future results.